Digital-Ally DVM-800, Operation Manual

Page: 26 / 56

Digital Ally, Inc. | Device Configuration
3-19
DVM-800 Operation Guide | 860-00186-00 Rev L
Go Back To
Table of Contents
• The Internal Events box consists of all the configured internal
DVM sensors. These consist of the manual record button, GPS, and
accelerometer sensors. These events must be higher in priority than
Pre-Event.
• The Pre-Event box is the Record Mode as defined in the Record Tab.
This box must be lower in priority than “Event Trigger” Type sensors
(#1 through #6).
Example 1: Reverse Camera Override Active
If multiple sensors are active, the Example 1 configuration above page tells us that the
Reverse Gear has event priority (LCD, camera switching, and Output Alarm) over all other
sensors. The Lights camera settings will have event priority (LCD, camera switching, and
Output Alarm) over all other sensors except the reverse gear if both are simultaneously
active.
Example 2: Reverse Camera Override Not Active
In Example 2 above, the reverse gear backup camera will be displayed on the LCD only
if the emergency lights and other record triggers are inactive . “Sensor Only” sensors
should be given lesser priority to avoid a situation where “Sensor Only” sensors could
override the Camera switching, LCD control, and Output Alarm control for an “Event
Trigger” type sensor.
Output Alarm
The IF Box Output Alarm signal is used to control the operation of the DWM Wireless
Microphone, or other optional equipment. When the output alarm is active, a 0VDC
signal is output to the BROWN wire of the IF Box cable harness. When not active, it is
an open circuit. The output alarm can also be utilized to switch auxiliary cameras using
optional equipment.
Output Alarm Name
By default the Output Alarm name is reserved for the Wireless Microphone and is
named as such. “Wireless Microphone” can be changed by editing the name field.
The name is used to identify the output for event recording playback and back office
storage.
Output Enable
Select which event or events will activate the Wireless Microphone using the drop down
arrows. The Output Alarm operation will follow Event Priority rules for the Wireless
Microphone. All external and internal sensors are listed and individually configurable.
By default, the output alarm is enabled for sensor 2 (Lights), sensor 6 (Wireless
Microphone), and the Record Button.
Settings: Ignore: The microphone/output alarm will not be activated.
Trigger: Enables the DVM to activate the output alarm when the
selected sensor is active.