Digisol DG-GS4826S, Management Manual

Page: 443 / 1344

C
HAPTER
16 | Multicast Filtering
Filtering and Throttling IGMP Groups
– 443 –
P
ARAMETERS
These parameters are displayed in the web interface:
u
IGMP Filter Status – Enables IGMP filtering and throttling globally for
the switch. (Default: Disabled)
W
EB
I
NTERFACE
To enables IGMP filtering and throttling on the switch:
1. Click Multicast, IGMP Snooping, Filtering.
2. Select Configure General from the Action list.
3. Enable IGMP Filter Status.
4. Click Apply.
Figure 253: Enabling IGMP Filtering and Throttling
C
ONFIGURING
IGMP
F
ILTER
P
ROFILES
Use the Multicast > IGMP Snooping > Filter (Add) page to create an IGMP
profile and set its access mode. Then use the (Add Multicast Group Range)
page to configure the multicast groups to filter.
CLI R
EFERENCES
u
"IGMP Filtering and Throttling" on page 1019
C
OMMAND
U
SAGE
Specify a range of multicast groups by entering a start and end IP address;
or specify a single multicast group by entering the same IP address for the
start and end of the range.
P
ARAMETERS
These parameters are displayed in the web interface:
Add
u
Profile ID – Creates an IGMP profile. (Range: 1-4294967295)
u
Access Mode – Sets the access mode of the profile; either permit or
deny. (Default: Deny)
When the access mode is set to permit, IGMP join reports are
processed when a multicast group falls within the controlled range.