Digisol DG-GS4826S, Management Manual

Page: 703 / 1344

C
HAPTER
26 | SNMP Commands
– 703 –
E
XAMPLE
Console(config)#snmp-server group r&d v3 auth write daily
Console(config)#
snmp-server user
This command adds a user to an SNMP group, restricting the user to a
specific SNMP Read, Write, or Notify View. Use the no form to remove a
user from an SNMP group.
S
YNTAX
snmp-server user username groupname [ remote ip-address ]
{ v1 | v2c | v3 [ encrypted ] [ auth { md5 | sha } auth-password
[ priv des56 priv-password ]]
no snmp-server user username { v1 | v2c | v3 | remote }
username - Name of user connecting to the SNMP agent.
(Range: 1-32 characters)
groupname - Name of an SNMP group to which the user is assigned.
(Range: 1-32 characters)
remote - Specifies an SNMP engine on a remote device.
ip-address - The Internet address of the remote device.
v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
encrypted - Accepts the password as encrypted input.
auth - Uses SNMPv3 with authentication.
md5 | sha - Uses MD5 or SHA authentication.
auth-password - Authentication password. Enter as plain text if the
encrypted option is not used. Otherwise, enter an encrypted
password. (A minimum of eight characters is required.)
priv des56 - Uses SNMPv3 with privacy with DES56 encryption.
priv-password - Privacy password. Enter as plain text if the
encrypted option is not used. Otherwise, enter an encrypted
password.
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
u
Local users (i.e., the command does not specify a remote engine
identifier) must be configured to authorize management access for
SNMPv3 clients, or to identify the source of SNMPv3 trap messages
sent from the local switch.