Digisol DG-FS4528P, Management Manual

Page: 868 / 973

C
HAPTER
42 | Multicast Filtering Commands
IGMP Query Commands
– 868 –
C
OMMAND
M
ODE
Global Configuration
E
XAMPLE
The following shows how to configure the query interval to 100 seconds:
Console(config)#ip igmp snooping query-interval 100
Console(config)#
ip igmp snooping
query-max-
response-time
This command configures the query report delay. Use the no form to
restore the default.
S
YNTAX
ip igmp snooping query-max-response-time seconds
no ip igmp snooping query-max-response-time
seconds - The report delay advertised in IGMP queries.
(Range: 5-25)
D
EFAULT
S
ETTING
10 seconds
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
The switch must be using IGMPv2/v3 for this command to take effect.
This command defines the time after a query, during which a response
is expected from a multicast client. If a querier has sent a number of
queries defined by the ip igmp snooping query-count command, but a
client has not responded, a countdown timer is started using an initial
value set by this command. If the countdown finishes, and the client
still has not responded, then that client is considered to have left the
multicast group.
E
XAMPLE
The following shows how to configure the maximum response time to
20 seconds:
Console(config)#ip igmp snooping query-max-response-time 20
Console(config)#
R
ELATED
C
OMMANDS
ip igmp snooping version (862)