Digisol DG-FS4528P, Management Manual

Page: 777 / 973

C
HAPTER
37 | EAPS Commands
– 777 –
C
OMMAND
U
SAGE
Enter the show eaps command without any argument to display a
summary of status information for all configured EAPS domains.
Enter the show eaps command followed by a domain name to display
detailed status information for the specified domain.
E
XAMPLE
This example displays a summary of all the EAPS domains configured on
the switch.
Console#show eaps
EAPS Status : Enabled
Number of EAPS Domains : 1
Domain State Mode Enabled Pri Port Sec Port Ctrl VLAN VLAN count
------------ ------------- ---- ------- -------- -------- --------- ----------
r&d Init M Y Eth 1/24 Eth 1/25 2 3
Console #
Table 110: show eaps - summary display description
Field Description
EAPS Status Shows whether EAPS is enabled on the switch.
Number of EAPS Domains Shows the number of EAPS domains configured on the switch.
Domain Displays the name of each domain followed by a brief list of status
information
State Shows the following EAPS states:
Master Node
Idle – The EAPS domain has been enabled, but the configuration
is not complete.
Init – The EAPS domain has started but has not yet determined
the status of the ring.
Complete – The ring is in the COMPLETE state for this EAPS
domain.
Failed – There is a break in the ring for this EAPS domain.
Transit Node
Idle – The EAPS domain has been enabled, but the configuration
is not complete.
Link-Up – The EAPS domain is running, and both of its ports are
up and in the FORWARDING state.
Link-Down – This EAPS domain is running, but one or both of its
ports are down.
Preforwarding – This EAPS domain is running, and both of its ports
are up, but the new link port is in a temporary BLOCKED state.
Mode Shows if the switch is a master or transit node.
Enabled Shows if the specified domain is enabled.
Pri Port Shows the primary port.
Sec Port Shows the secondary port.
Ctrl VLAN Shows the Control VLAN ID.
VLAN count Shows the number of Protected VLANs in this domain.