Digisol DG-FS4528P, Management Manual

Page: 522 / 973

C
HAPTER
24 | SNMP Commands
– 522 –
snmp-server group
This command adds an SNMP group, mapping SNMP users to SNMP views.
Use the no form to remove an SNMP group.
S
YNTAX
snmp-server group groupname
{ v1 | v2c | v3 { auth | noauth | priv }}
[ read readview ] [ write writeview ] [ notify notifyview ]
no snmp-server group groupname
groupname - Name of an SNMP group. (Range: 1-32 characters)
v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
auth | noauth | priv - This group uses SNMPv3 with
authentication, no authentication, or with authentication and
privacy. See "Simple Network Management Protocol" for further
information about these authentication and encryption options.
readview - Defines the view for read access. (1-32 characters)
writeview - Defines the view for write access. (1-32 characters)
notifyview - Defines the view for notifications. (1-32 characters)
D
EFAULT
S
ETTING
Default groups: public
14
(read only), private
15
(read/write)
readview - Every object belonging to the Internet OID space (1).
writeview - Nothing is defined.
notifyview - Nothing is defined.
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
A group sets the access policy for the assigned users.
When authentication is selected, the MD5 or SHA algorithm is used as
specified in the snmp-server user command.
When privacy is selected, the DES 56-bit algorithm is used for data
encryption.
For additional information on the notification messages supported by
this switch, see Table 10 , “ Supported Notification Messages .” Also, note
that the authentication, link-up and link-down messages are legacy
traps and must therefore be enabled in conjunction with the snmp-
server enable traps command.
E
XAMPLE
Console(config)#snmp-server group r&d v3 auth write daily
Console(config)#
14. No view is defined.
15. Maps to the defaultview.