18 Installer’s Guide
5.3 P
ROGRAMMING
R
EMOTE
C
ONTROL
B
UTTONS
SECTIONS
[501]
TO
[516]
For each remote control, each button or a combination of the buttons pressed
simultaneously can be programmed to send a signal to the control panel to perform
certain actions as if users had gone to a keypad and entered their
User Access
Codes
. When a user arms or disarms using the remote, the control panel will arm or
disarm
all
the areas assigned to the
User Access Code
. For example, you arm with
a remote control whose
User Access Code
is assigned to areas 1 and 3, the control
panel will attempt to arm areas 1 and 3.
Each section from
[501]
to
[516]
represents the remote control assigned to the
sections
[301]
to
[316]
(see section 5.1 of this manual). For example, the buttons for
the remote control assigned in section
[301]
will be programmed in section
[501]
.
Figure 5.1: Remote Controls with button identification
When you enter each section from
[501] to [516]
, each digit represents a button or a
combination of buttons pressed simultaneously.
Summary of Contents for DGP-319
