Digiplex DGP-319, Installer'S Manual

Page: 16 / 26

14 Installer’s Guide
From Step 5 in Figure 3.1, page 6:
1) Enter the desired section from
[101] to [116]
2) Enter the serial number of the detector or contact switch
If you are unable to find the serial number, refer to section 3.12 of this
manual.
SECTIONS
[020]
AND
[021]
The number of devices assigned to sections [101] to [108] can be viewed in section
[020] . The number of devices assigned to sections [109] to [116] can be viewed in
section [021] .
In section [021] devices assigned to sections [109] to [116] appear as 1
through 8. For example, the device assigned to section [109] would appear
as 1 in section [021] .
Devices can also be deleted through these sections. Use Feature Select
Programming (see section 3.1.1) to delete device(s) by pressing the corresponding
key(s). For example, to delete the device assigned in section
[109] , press the [1]
key in section [021] , and then press [
ENTER
] .
4.2 A
SSIGNING
D
ETECTORS
& C
ONTACT
S
WITCHES TO
Z
ONES
Once the detectors and the contact switches have been assigned to the Wireless
Bus Module, they must be assigned to zones in the control panel. For instructions on
how to assign the devices to the zones and then program the zones, refer to the
Digiplex Control Panel's Reference & Installation Manual .
Zones assigned to detectors or contact switches cannot be programmed
as Fire Zones.
4.3 V
IEWING
S
IGNAL
S
TRENGTH OF
D
ETECTORS
& C
ONTACT
S
WITCHES
SECTIONS
[201]
TO
[216]
Once the detectors and/or contact switches have been installed and assigned to the
Wireless Bus Module, the average signal strength of each device can be verified in
these sections by briefly holding the tamper switch or opening the zone. Each
section represents the signal strength viewer for a specific device. For example,