Digiplex DGP-319, Installer'S Manual

Page: 10 / 26

8 Installer’s Guide
3.3 C
HECK
-
IN
S
UPERVISION
SECTION
[001]:
OPTIONS
[2]
AND
[3]
The Wireless Bus Module waits for each of its assigned detectors and/or contact
switches to send a status signal within a specified time period to confirm their
presence and functionality. If a device has not sent a signal within the time period,
the Wireless Bus Module will transmit a supervision loss signal to the control panel.
The control panel can generate a trouble, an alarm and/or can transmit a report
code to the monitoring station. For details refer to the
Digiplex Reference &
Installation Manual. Option [2] enables the Check-in Supervision feature and option
[3] specifies the time period required for the devices to send their signal.
From Step 6 in Figure 3.1, page 6, enable or disable the options:
Option
[2] OFF = Check-in Supervision disabled
Option [2] ON = Check-in Supervision enabled (default)
Option [3] OFF = Check-in every 12 hours (default)
Option [3] ON = Check-in every 12 minutes
Ensure that the assigned detectors and/or contact switches are set to the
same time period as the Receiver Module (i.e. if the Receiver Module is set
to Check-in every 12 minutes, the detectors/contact switches must be set to
Check-in every 12 minutes.
3.4 T
AMPER
S
UPERVISION ON
R
ECEIVER
M
ODULE
SECTION
[001]:
OPTION
[4]
If this option is enabled and the Receiver Module's cover is removed, the on-board
tamper switch will be triggered. When this occurs, the Wireless Bus Module will
transmit a tamper signal to the control panel. The control panel can generate a
trouble, an alarm and/or can transmit a report code to the monitoring station. For
details refer to the
Digiplex Reference & Installation Manual.
From Step 6 in Figure 3.1, page 6, enable or disable the option:
Option
[4] OFF = Receiver Module's Tamper Supervision disabled (default)
Option [4] ON = Receiver Module's Tamper Supervision enabled