Digiplex DGP-319, Installer'S Manual

Page: 18 / 26

16 Installer’s Guide
5.0 REMOTE CONTROLS
To program the remote controls:
1) Remote controls must be assigned to the Wireless Bus Module
2) The remote controls from the Wireless Bus Module must be assigned to
User
Access Codes in the Digiplex Control Panel .
3) The buttons on the remote controls must be programmed
Complete the Programming Guide while assigning the remote controls. The
serial numbers will be needed when assigning the remote controls to User
Access Codes. Also, knowing which User Access Code was assigned to
which remote control may affect how the remote's buttons are programmed.
Sections [030] , [031] , [301] to [316] , [401] to [416] , and [501] to [516] are all
interrelated.
For example, when assigning a remote control to the Receiver Module:
1) The serial number will be entered in section
[301]
2) It will automatically appear in section [030]
3) It is assigned to a User Access Code in section [401]
4) Its buttons are programmed in section [501]
When using the remote controls, users must press the button(s) until the red
LED on the remote control illuminates. This short delay (0.25 sec.) before
sending a signal is to avoid accidental transmissions. After pressing and
holding a button continuously for five seconds, the remote control will no
longer transmit any signals until the button is released and pressed again.
5.1 A
SSIGNING
R
EMOTE
C
ONTROLS TO THE
R
ECEIVER
M
ODULE
In these sections you will assign the remote controls to the Receiver Module. Up to
16 remote controls can be assigned to each Receiver Module.
SECTION
[301]
TO
[316]
Enter the serial numbers from the remote controls in the sections [301] to [316] .
When one section is programmed, the keypad will automatically switch to the next
section.