Digiplex DGP-319, Installer'S Manual

Page: 15 / 26

Digiplex Liberator 13
4.0 DETECTORS AND CONTACT SWITCHES
Programming for the wireless transmitters is accomplished in three steps:
1) Assign the detectors and contact switches to the Wireless Bus Module.
2) The detectors and contact switches from the Wireless Bus Module must be
assigned to zones in the Digiplex Control Panel.
3) The zone parameters must be defined in the Digiplex Control Panel.
For more details concerning zones, refer to the Digiplex Control Panel's Reference
& Installation Manual .
Complete the Programming Guide while assigning the detectors and
contact switches. The serial numbers and the inputs that they are assigned
to will be needed when programming the zones in the control panel.
Sections [020] , [021] , [101] to [116] , and [201] to [216] are all interrelated.
For example, when assigning a detector or contact switch to the Receiver Module:
1) The serial number and input number will be assigned in section
[101]
2) The number of devices will automatically appear in section [020]
3) Its signal strength can be viewed in section [201]
4.1 A
SSIGNING
D
ETECTORS
& C
ONTACT
S
WITCHES TO
R
ECEIVER
In these sections you will assign the detectors and contact switches to the Wireless
Bus Module. Up to 16 detectors or contact switches can be assigned to each
Receiver Module.
SECTIONS
[101]
TO
[116]
Enter the serial numbers of the detectors and contact switches in the sections [101]
to [116] . The serial numbers can be found inside the devices. Inputs 001 to 016 are
automatically assigned when the serial number is entered. For example, Section
[101] is assigned to input 001, Section [102] is assigned to input 002, etc. When one
section is programmed, the keypad will automatically switch to the next section.