5
NVR and hDVR Systems Setup Guide
SECTION 2: GETTING STARTED: UNPACKING YOUR SYSTEM
Notes:
•
IP devices
– systems are compatible with many IP devices such as DIGIOP® and Observint Technologies BLACK and The
BLACK Line cameras and encoders, and many AXIS
®
, Sony
®
, Arecont
®
, Canon
®
, IQEye
®
, ACTi
®
, LG
®
, 3S and other manufacturer’s
cameras and encoders.
•
NTSC
or
PAL
– systems are compatible with NTSC or PAL, respectively, analog cameras.
•
Ground loops and power fluctuations
– To ensure high-quality image capture and to prevent issues, check the system
for ground loops and power fluctuations across the whole system.
•
Low-light adjustments
– Adjust the lighting, focus, or iris of the camera properly to avoid unnecessary motion detection in
low-light conditions.
•
PTZ
– systems do not support PTZ data signals or power on the video coax cables. Run separate cables to accommodate
system needs.
•
Audio
– All units come with at least one channel of audio; some come with multiple channels.
•
Voice recording
– Plug the microphone for voice recording into the microphone input jack. When the audio signal is line
level, then connect to the line-in jack. Connect the speaker to replay the recorded audio. The output signal is line level and
requires an amplifier to boost the output signal for a speaker.
•
Sensor inputs
– These are activated by dry contact devices (the contact of a relay that does not make or break a current;
usually some other relay or device starts or stops the current) and are not “balanced.” Inputs connect to either N/O (normally
open) or N/C (normally closed) sensor contacts. Each input is configured in the software, depending on the input type. To
confirm correct operation, close the sensor device for at least 0.5 seconds.
•
Sensor outputs
– These can be activated automatically with DIGIOP® Control, or manually with DIGIOP® Connect.
•
Relays
– When using the Relay outputs, ensure that the voltage/current capacity of the relays is not exceeded.
•
Network Connections
– The Network settings are used to configure your system for DIGIOP® Control, DIGIOP® Connect,
and DIGIOP ELEMENTS™ accounts.
•
IP devices
– When using IP devices, to ensure that adequate bandwidth is available for system operations and video
transmission, set up a separate or segregated network. See the IP device manufacturer’s recommendations for bandwidth
requirements.
•
Printers
– If you are using a printer, make sure to use a good quality, color printer and appropriate paper to achieve optimal
results.
