MIL-3000FTX Series of FastPort Print Servers
9-4
•
SNMPAXXXXXX
: This device was discovered by the SNMP over NetBIOS
(where XXXXXX are the last six digits of the Ethernet address. Thus, a
device with an Ethernet address of “0040C800702CA,” has a NetBIOS
name of
SNMPA0702CA
).
Note:
FastPorts with firmware of 6.1 or higher are required for SNMP over NetBIOS
manageability.
•
UNKNOWN
: The device was discovered by the SNMP over IP protocol;
however, there was no entry in the host table relating to this device.
Add a name in the “Show Node Properties” menu (refer to section
9.4.9).
9.4
Discovery Application Tools
9.4.1 Renaming a Discovery Map
Maps can be renamed and saved for future use. Do the following to
rename a Map.
1. Click the
Rename Map
icon (fourth from the left). The “Map Title
Editor” menu appears.
2. Delete the old name and type in a new Map name.
3. Click
OK
.
To perform this task from the pull-down menu, select
Change title
from
the
Options
pull-down menu.
9.4.2 Host Name/Address
For each thumbnail shown on the Map, there will be a name below device.
Each protocol has its own criteria, for example:
• For an IP device, the address is its IP Address.
The name for an IP device is
Host Name
. This is derived from the host
file. If an entry for an IP address is not found,
UNKNOWN
is displayed.
See Section 9.4.9 to change a name.
• For an IPX device, the address is its IPX address.
The name for an IPX device is the
IPX SAP Name
. This name cannot be
changed.
• A NetBIOS unit doesn’t have an address, so
0:0
is shown.
The name for a NetBIOS device is the
NetBIOS Name
. This cannot be
changed.
