T U R N O F F
EN
DiBO 39
TRANSPORT
1
Machine
Close the protection cover. Check the pressure of the tires (ca 4 bar) and
profile depth. Couple the JMB-M and make sure that the drawbar is connected
firmly. By pulling the drawbar with ball coupling powerful up you can check if
the coupling is firmly atached. Turn up the jockey wheel and lock it. Attach the
breakaway cable carefully on the towing hook eye it’s meant for.
This cable is a safety precaution and is used as an emergency break, when
suddenly the coupling gets loose during driving. Attach the electrical cable
for the lighting, and check it. Unlock the hand brake (if present) and remove
the wheel blocks. The JMB-M must always be provided with a good readable,
official registration plate, according to the applicable regulations to your country.
The plate must be attached properly on the back and the lighting lights the
complete plate.
Caution, make sure the jockey wheel is turned into the
driving direction. Please also ensure that the jockey
wheel will not hit the brake system / drain tap. Set the
jockey wheel like shown in picture on the left.
2
Battery
Lifting the battery can be done by using the two lifting points as shown in the
picture left.
During the lifting process there should never be
persons below the battery system!
STORAGE AT FREEZING TEMPERATURES
Frozen water in the cleaner could damage parts of the cleaner. Remove the
water from the trailer at frost temperatures, turn the jockey wheel of trailer
completely down and open the drain valve in the front of the trailer. Pay
attention on descaling product, always remove the tank and put away frost free!
1 A N T I F R E E Z E F I L L I N G F U N C T I O N
Turn off the cleaner and remove the lance from the spray gun. Drain the
remaining water from the tank through opening the drain valve in front of the
trailer. Add antifreeze (for mobile application, +- 15 litres) to the water supply
tank (loosen the cover of the water tank), to fill with antifreeze.
Put the electrical contact to position ‘ON’ (machine
not started)! Move the control stick downwards and
simultaneously turn the key switch to position “START”.
The antifreeze filling function indicator is now active and appears on the display
for 1.5 minutes! Start the machine at idle speed! Spray till the antifreeze water
flows out of the spray gun (this indicates that the cleaner is filled with antifreeze)
or wait till the antifreeze filling function time is ended.
Remember:
l
oosen also the spray gun once, this to fill the bypass line
with antifreeze. 5 seconds after extinguishing of the lamp, the cleaner
will stop on “run dry water”. The cleaner is now filled with antifreeze,
turn off the key contact and store the cleaner in a storage area.
Remark: pay attention to the water supply hose & supply water
filter, these are not filled with antifreeze agent! You can uncouple
the supply hose/water filter and put away the hose/filter frost free.
You also can drain the water from the hose (eg.: by blowing with
compressed air) or through the water filter (by loosening the basket
and draining the water from the hose). Also pay attention to the
option filling pump and associated filter: drain water / extract from
the supply line. Afterwards, turn on the filling pump and fill the
supply line with antifreeze (by means of a tank at height). Do not fill
/ blow off under pressure or compressed air at any circumstances!
1
low pressure coupling
2
safety valve
3
high pressure coupling