Dexter Laundry Wn0600ea-13en2x-sskcs-usx, Parts & Service Manual

Page: 61 / 159

Tub Back, Bearing, and Cylinder Assembly T-600
Reassembly:
Reverse the procedures to the
left paying attention to the
following areas
Step 1: Lay the washer on its
front. Note: Put a thick
pad across the front of the
washer, above the door, to
protect the handle and coin
acceptor.
Step 2: Make sure the bearing
housing weep holes are
located at 12 o’clock and 6
o’clock.
Step 3: Clean the silicone rubber
from the back of the outer
tub and the perimeter of
the tub back where the two
meet. There is no gasket in
this area.
Step 4: Apply a new bead of silicone
rubber around the back of
the outer tub. (see picture)
Step 5: Lower the tub back, bearing
and cylinder assembly into
the washer outer tub.
Step 6: Torque all bolts according to
the following charts.
Removal
Step 1: Remove the top and back panel as described.
Step 2: Move the rear channel, that the water valves mount
to, forward by removing the five mounting screws.
Step 3: Remove the drive belt.
Step 4: Remove the overflow hose, tub fill hose, and pressure
switch hose from the back of the tub.
Step 5: Mark the tub back and bearing assembly for ease in
assembly later. (see picture)
Step 6: Remove the 12 bolts and nuts from the perimeter of
the tub back clamp ring. (Two of the twelve bolts are
longer and go through the thicker part of the brace
where it connects to the frame.)
Step 7: Remove the 2 bolts that fasten the clamp ring to the
frame.
Step 8: The entire tub back and cylinder assembly may be
lifted out of the tub (it may be necessary to break
the adhesion of the silicone that seals the tub back
to the tub). Blocks should be placed under the edges
of the cylinder before setting it down to prevent
damage to the cylinder flange.
Part # 8533-097-001 11/16
61