Dexter Laundry Wn0600ea-13en2x-sskcs-usx, Parts & Service Manual

Page: 24 / 159

Operating Instructions
1. Ensure that power is turned on to the washer.
2. Ensure that the ADVANCE/RUN/PROGRAM key lock is in the RUN position.
3. Load the clothes loosely in the cylinder and latch the door securely. Be sure clothing does
not get caught between the door gasket and tub front when closing the door.
NOTE: To begin closing the door, the handle must be in the horizontal position. After moving the door
to the closed position, the handle must be turned down to the vertical position in order to latch the door for
machine operation.
4. Select one of the thirty cycles, by using the SCROLL UP/SCROLL DOWN buttons to
change the number indicated in the two digit LED display. The selection is made when the
number indicated corresponds with the desired cycle.
5. If you are manually adding wash compounds, add low sudsing powdered detergent in the
amount shown below into the detergent compartment on top of the machine or in front
soap compartment.
Location is illustrated on the black cover on the top of the machine. This compartment
will be flushed during the WASH segment of the cycle. Rinse conditioners may be added
to their own compartment if desired. This compartment will be flushed during the FINAL
RINSE segment of the cycle.
6. If you wish to manually add bleach during the cycle, add bleach in the round opening in
the top of the machine. Location is illustrated on the black cover on the top of the machine.
NOTE: Any additional washing compounds may be added at the appropriate time by pouring into the
round opening in the top.
7. Push the green START button to start the cycle.
8. The cycle time remaining is displayed throughout the cycle. The cycle number in operation
can be displayed by pushing and holding START, then push SCROLL UP. The cycle
number will be displayed as long as these two buttons are depressed.
The actual bath temperature can be displayed by simultaneously pushing the START and
SCROLL DOWN button.
Soak
- At any time during the cycle, the red
STOP
button can be depressed to stop the
washer timer from counting down. All washer cycle information is retained and the door
remains locked. The washer will soak the load for 15 minutes, then agitate for 30 seconds.
This will repeat until the cycle is started again. This feature allows for an extended soak if required. The
washer cycle will continue when the
START
button is depressed.
NOTE:
The selected cycle can be cleared at any time by depressing and holding the
STOP
button for
a minimum of three seconds.
End of Cycle
At the end of the cycle the machine stops, the END CYCLE LED lights, the alarm sounds, and the loading
door unlocks allowing unloading of the machine.
Safety Door Lock
This machine is equipped with a Safety Door Lock which prevents opening the door if power is interrupted,
until it is safe to do so.
Part # 8533-097-001 11/16
24