Dexter Laundry Wn0600ea-13en2x-sskcs-usx, Parts & Service Manual

Page: 41 / 159

Part # 8533-097-001 11/16
41
Diagnostic Test Cycle (#31)
There is a diagnostic test cycle to assist in both verifying correct operation and identifying functional problems.
The test cycle is operated by following these steps:
1. Close the washer door
2. Turn the Run/Program Key to the Program Position. The program mode LED (bottom row right side) will
light.
3. Select Test Cycle #31 by using the Up and Down Arrows on the touch pad. Read the Test Cycle number in the
display.
4. Push the green Start button. All lights will be on and “00” will be in the display.
5. Push the Up arrow to select the following steps:
6. Injection signal can not be tested for output in this cycle
When the correct step is selected for the component that is to be tested, push the Start button to operate
that component. Releasing the Start button removes power to the component being tested.
Step 1: Door Locking Solenoid
(Door Sol.# 3 red output light will be lit. Green input #3 and #4 should
be lit.
Step 2: Door Locking Thermoactuator
(Lock Thermo # 2 red output will be lit.)
Step 3: Door Unlocking Thermoactuator
(Unlock Thermo # 1 red output will be lit.)
Step 4: Close Drain Valve
(Drain Valve # 4 red output light will be lit.)
Step 5: Cold Water Valve for the tub
(Cold Tub # 7 red output light will be lit.) The pressure switch low
level setting can be tested at this point. The drain valve is closed and cold water is on for as long as
the START button is pushed When the water level reaches a low level,the water valve will turn off and
no additional cold water can be added. (Green input LED #13 should now be lit).
Step 6: Cold Water Valve for the dispenser
(Cold Dispenser # 6 red output light will be lit.) The pres
sure switch low level setting can also be tested with this step. (See step 5)
Step 7: Hot Water Valve for the tub
(Hot Tub #5 red output light will be lit.) The pressure switch high
level setting can be tested at this point. The drain valve is closed and hot water on for as long as the
START button is pushed. When the water level reaches a high level, the water valve will turn off and
no additional hot water can be added. (Green input led #15 should now be lit.)
Step 8: Hot Water Valve for the dispenser
(Hot Dispenser # 8 red output light will be lit. ) The pres
sure switch high level setting can also be tested with this step. (See step 7)
Step 9: Tumble clockwise
(FWD. #13 red output light will be lit)
Step 10: Tumble counter clockwise
(REV. #14 red output light will be lit)
Step 11: Open Drain Valve
(insures that drain valve is open before spin)
Step 12: Intermediate Extract
(Rev.#13 and Speed1 #15 red output light will be lit.)
Step 13: High Speed Extract
(Rev.#13 and Speed 1#15 and Speed 2 #16 red output light will be lit.)
Warning:
If the washer has had any of the 30 cycles changed from the factory settings,
do not use Step 14 unless you want to reset all 30 cycles back to the factory settings.
Step 14 will delete any changes made to all 30 cycles.
Step 14: Reset all 30 Cycles to Factory Settings
(must push the
Start
Button and hold it, then
push the Up Arrow button to reset to Factory Settings)
To Exit the Test mode, push the red
Stop
button and turn the Run/Program Key back to the Run position.