Dexter Laundry Wn0600ea-13en2x-sskcs-usx, Parts & Service Manual

Page: 25 / 159

If power failure occurs, it will be necessary to wait 2 to 3 minutes before the door can be opened.
Motor Drive indicators
There is a five digit, seven segment, display on the drive which can be viewed by removing the access cover
at the top rear of the washer. There are also small L.E.D.s on the left and bottom edge of the display that
can be viewed and used for troubleshooting. The five seven segment digits will change value depending on
where the washer is during the wash cycle.
Computer Contol Indicators
Computer control OPL machine has 30 different selectable cycles; 29 of the 30 cycles are preset with the
most common industry applications. See the Preset Cycle Information sheets for complete cycle information.
If these cycle settings do not meet the required application, each cycle is re-programmable by the user,
simply and reliably.
Each cycle has up to 9 baths which are Flush, Pre-wash, Wash, Rinse 1, 2, 3, 4, 5 and Final Rinse/Extract.
There are five user selectable settings within each bath to allow cycle tailoring to meet exact applications.
The settings and the limits of each are shown in the table below. The Scroll Up/Scroll Down buttons are
used to change the settings.
Bath Setting Limits
Cycle Time - 0 to 30 minutes (1 minute increments)
The Cycle time (tumble) settings are 0 minutes to 30 minutes in 1 minute increments for
each bath. If the setting is 0, then that bath is skipped over. For the Final Rinse /Extract
bath, the minimum time must be 1 minute.
Water Temperature - Hot, Warm, Cold, Empty, (20-90C if heated model)
The water temperature setting is displayed as HH = hot, CH = warm, CC = cold, EE = No
water bath, 20-90C in 5 degrees increments. When the No Water or EE bath is selected,
the water level can be set to either high or low and NO Injection will be made even if the
injection source is programmed. Maximum temperature for final rinse is 60 C.
Water Level - High or Low
The water level setting is displayed as HI for high level and LO for low level.
Injection Source 0 to 6
The injection source settings are 0 through 6 with 0 being no injection and settings 1 through
6 relating to an injection source. See Recommended Injection Table.
Spin Time - 0 to 10 minutes (1 minute increments)
The spin time settings are 0 minutes to 10 minutes in 1 minute increments. If the setting is
0, there is no spin for the bath. Final Rinse/Extract minimum setting is 1 minute.
Part # 8533-097-001 11/16
25