Dexter Laundry Wn0600ea-13en2x-sskcs-usx, Parts & Service Manual

Page: 29 / 159

Part # 8533-097-001 11/16
29
then use the SCROLL UP/SCROLL DOWN buttons to change the injection source. See the
Injection Source table for proper selection. If zero is selected, then no injection source is active
for this segment. When the desired injection source is selected, continue to the next instruction.
When the No Water or EE bath is selected, injection signals are prohibited by the electronic
controller. The programmed injection source value is ignored.
10. Push the green ENTER button. (The injection source has now been entered.)
The Spin Time LED lights and the Injection Source LED is out. The spin time for this segment is
displayed. If no change is required, then continue to the next instruction. If this value requires
changing, then use the SCROLL UP/SCROLL DOWN buttons to change the spin time in 1 minute
increments to the desired value, then continue to the next instruction. Settings range is from 0
minutes to 10 minutes, except for the Final Rinse/Extract segment where the setting range is 1
minute to 10 minutes. REMINDER: If the spin time is set to zero, there will be no spin at the
end of the bath.
11. Push the green ENTER button. (The extract time has now been entered.)
Once depressed, the Spin Time LED is out and the editing of one segment is complete. The next
sequential cycle segment LED lights, unless the segment edited above was the Final Rinse/Extract
segment. If the Final Rinse/Extract segment is edited, after step eleven, the cycle programming is
complete, and the machine will return to the Programming Mode awaiting a cycle select (Step 3).
To exit the programming mode, depress the red STOP button when one of the nine cycle
segment LED lights are lit. The programming changes made prior to the program exit are
retained and the cycle is updated.
Cycle Times
Cycles 1-30 Chemical Signal Water Level Water Temp
Flush 0-30 min. 1-6 High or low Hot, Cold, Warm or Empty
Drain 40 sec.
Int. Spin 0-10 min.
Prewash 0-30 min. 1-6 High or low Hot, Cold, Warm or Empty
Drain 40 sec.
Int. Spin 0-10 min.
Wash 0-30 min. 1-6 High or low Hot, Cold, Warm or Empty
Drain 40 sec.
Int. Spin 0-10 min.
Rinse 1 0-30 min. 1-6 High or low Hot, Cold, Warm or Empty
Drain 40 sec.
Int. Spin 0-10 min.
Rinse 2 0-30 min. 1-6 High or low Hot, Cold, Warm or Empty
Drain 40 sec.
Int. Spin 0-10 min.
Rinse 3 0-30 min. 1-6 High or low Hot, Cold, Warm or Empty
Drain 40 sec.
Int. Spin 0-10 min.
Rinse 4 0-30 min. 1-6 High or low Hot, Cold, Warm or Empty
Drain 40 sec.
Int. Spin 0-10 min.
Rinse 5 0-30 min. 1-6 High or low Hot, Cold, Warm or Empty
Drain 40 sec.
Extract 1-10 min.
Total * 1-320 min.
* Cycle times are approximate and do not include fill time from empty to low level.
* Fill time from low to high level is included as computer operates during this period.