Dexter Laundry Wn0600ea-13en2x-sskcs-usx, Parts & Service Manual

Page: 50 / 159

Water does
not flush soft -
ner compart-
ment
Water Valves Check to insure that water valve is operating. If not, check for
120VAC to water valve from Input/Output PCB. If 120VAC, change
water valve. If no voltage check Input/Output PCB.
Fill Hose Screens
Water Valve Screens
Check all screens for obstructions and clean.
Water
Check to insure that water is turned on and operating
.
Water Level
too high
Pressure Switch Pressure switch must be in the low or high position to close the
circuit to the Input/Output PCB. Either the green low level #13 or
high level light #15 on the Input/Output PCB must be lighted.
Check pressure switch continuity between terminals #31 & #22
for low level and #31 and #32 for high level.
Pressure Switch
Hose
Check hose for holes. Be sure the inlet end of the large part of the
hose is lower than the rest of the hose and is free of debris.
CPU Board, Ribbon
Cable, Input/Output
PCB
Check Input/Output PCB for illuminated green low #13or high lev-
el input light #15. If green input light is illuminated, check single
red light on CPU board. Single red light should be illuminated. If
light is flashing or not on, remove power from washer for 2 min -
utes to reset board. Reapply power to washer and check red CPU
light. If on solid, CPU okay. If still flashing or not on, replace CPU
board. If CPU tests okay, change Ribbon Cables between CPU and
Input/Output PCB.(Check with factory for latest testing procedures
for I/O PCB) If still not corrected, change Input/Output PCB.
Water comes
in but level
does not rise
Drain Valve Check these areas
- Drain valve blockage
- Drain valve motor and gear train. If power but drain valve does
not close, replace valve.
- Power to the drain valve. If no power to drain valve, check (brn/
yel) circuit for power.
Water Valves Check or replace diaphrams
Water drains
slowley
Drain System Check hoses and drain valve for blockage. Clean if necessary.
Check building drains for blockage or inadequate size.
Water leakage
around loading
door
Door Adjustment Door may need adjustment due to abuse or wear around loading
Check tightness around perimeter using a dollar bill. Adjust left to
right tightness by shims at door lock or hinge side. It is important
to center gasket to tub opening before tightening door to hinge
bolts. Chalk may be used on tub front to show point of contact
with tub. If gasket is deformed, worn, or damaged, replace.
Refer to parts section for door gasket expander kit.
Excessive
vibration
Mounting System Check these areas: Strength of mounting
structure, concrete, or base. Mounting bolts may
be loose and need tightening.
Drive Belt Worn drive belt can cause vibration and noise.
Pulleys Damaged pulleys.
Underloading NOTE: SMALL LOADS CONTRIBUTE TO OUT OF BALANCE LOAD-
ING AND INCREASE VIBRATION.!!!
Symptom Probable Cause Suggested Remedy
Part # 8533-097-001 11/16
50