Dexter Laundry Wn0600ea-13en2x-sskcs-usx, Parts & Service Manual

Page: 40 / 159

Part # 8533-097-001 11/16
40
Rapid Advance Mode
To enter the Rapid Advance mode, insert the key into the Rapid Advance/Run/Program lock and turn
the key counter-clockwise (CCW). The Rapid Advance mode must be entered during the cycle. If the
cycle has not yet started, press the “DOWN” button or the “UP” button to choose a cycle and then the
“START” button to begin the cycle.
To advance to the next step in the cycle, push both the “UP” and “ START ” buttons at the same time. The
display will show “Ad” (advance).
If advancing during a bath, all water valves will turn off and the drain will open until the “ open drain”
step is completed. The cycle will then continue to the next bath or to the spin of the current bath if the
programming includes spin time.
If advancing during a chemical injection of a bath or after a chemical injection of the bath but before the
low water level is reached, the injector will turn off and the hot and the cold water valves to the tub will
turn on until the low water level is reached or for 30 seconds, whichever comes first. Then the drain will
open and proceed to the next step after the Aopen drain@ step is completed.
If advancing before a chemical injection of the bath, the drain will open immediately and the cycle will
proceed to the next step when the “open drain” step is completed.
If advancing during a spin, the tumbler will begin to decelerate immediately. However the cycle may
proceed to the next bath before the tumbler comes to a complete stop. The cycle cannot be advanced
further while the tumbler is decelerating.
If a temperature PCB is installed in the I/O PCB and the temperature programmed from 20 to 90 (Celsius),
advancing will turn off the heater relay or steam valve immediately, if either is on, and open the drain
after a three second delay. If the display shows a water temperature from 65 to 90 (may be displayed
by pressing the “ DOWN ” and “ START ” buttons together), the drain will close again when the washer
indicates empty and the hot and the cold water valves to the tub will turn on until the low water level is
reached. The cycle will then continue to the next bath, or if programmed, to the spin of the current bath.
To exit the Rapid Advance mode during the cycle, turn the key to Run. The cycle will continue
normally.
Notes:
• The cycle cannot be advanced during the open drain@ step of the bathes.
• The cycle cannot be advanced when the hot and cold water valves to the tub are on after advancing
during or after a chemical injection.
• The cycle cannot be advanced again while the hot and cold water valves to the tub are on after
advancing when the water temperature was 65 to 90.
• The Rapid Advance mode may only be entered after a cycle is started.
• The indicator lights will show which segment the cycle has been advanced.
• The Rapid Advance mode cannot skip the final three tumbles of the cycle. The door lock
may remain activated for a couple minutes after the cycle has been completed.
• The chemical injection signals will not turn on if the Rapid Advance mode is entered before
the injection.
To end the cycle without waiting for the time to count down, push and hold the “STOP”button
for 5 seconds or more. The display will then show the cycle number and be ready to start the
next cycle.