Dexter Laundry Wn0600ea-13en2x-sskcs-usx, Parts & Service Manual

Page: 58 / 159

Loading Door Disassembly
Loading Door Reassembly
Step 1: Remove the loading
door as outlined above.
Lay the door on a flat
surface with the glass
down
Step 2: While holding down
on the door glass, lift
up on the door ring
and roll back the lip of
the gasket with your
fingers.
S tep 3: Work all the way
around the gasket and
the glass is out.
Step 1: Lay the door ring face
down on a flat surface.
Start the glass into one
side of the door gasket.
Step 2: Use one hand
underneath to push
the gasket out and the
other hand on the top
pulling the gasket in
place
Step 3: The front lip of the
door gasket should
be checked for proper
seating.
Front Control Panel Name Plate Decal
The name plate on washer front is adhesive backed.
Front Control Panel Name Plate Removal
The name plate may be removed by simply peeling it off.
Re-Installation of Name Plate
Step 1: Remove any remaining glue from the control panel.
Step 2: Before removing the paper backing from the name plate, check fit to the control panel. The
program push buttons are the locating guides.
Step 3: Remove the paper backing from the right side of the name plate, position it on the panel and
press right end into place. Peel the backing from the left end and press into place.
Part # 8533-097-001 11/16
58