Dexter Laundry Wn0600ea-13en2x-sskcs-usx, Parts & Service Manual

Page: 21 / 159

• If power is 208-240-1PH-60Hz, connect L1, L2 and Ground.
Note: Use a UL approved receptacle with proper external ground.
NOTE: It is important that the grounding screw next to the power terminal
block TB-1 be connected to a good external ground.
Controls Transformer
The controls transformer is located inside the control trough and steps a range of 208 to 240 volts down
to 115 volts. There are two terminals on the controls transformer
for the primary (incoming) power. Use the terminal marked “208V”
for power supplies between 200 and 215 volts. Use the terminal
marked “230V” for power supplies between 216 and 240 volts.
NOTE: L1 on the transformer must be set at proper
tap for proper operation.
Electrical Connections
Electrical power connections are made to the small terminal block located in the rear of the machine.
The terminal block is accessed by removing the access cover.
• 1 Phase or 3 Phase connections
• 208-240 volts, 60 Hz.
• 2 or 3 wire plus ground
• Suggested Minimum Wire Size -- 12 Ga.
Fusing Requirements:
Dual element time delay fuse or equivalent breaker of
amperage specified below.
• 1 Phase or 3 Phase 15 amp
• T-600
• 1 Phase or 3 Phase 20 amp
• T-900 or T-1200
Rotation in extract as viewed through glass door at front of washer models will be counter-clockwise
WARNING
Always disconnect electrical power to the
machine before performing any adjustments
or service.
Part # 8533-097-001 11/16
21