DS-CAL
SOFTWARE USER MANUAL
8.5.3. Dewesoft UUT without CAN port
This following applies only if you use an older version of the DS-CAL test board and you have a
Dewesoft UUT without CAN port!
An additional DS-CAN2 instrument must be connected to the PC performing calibration procedure
along with the UUT if any of the following DS-CAL test board versions is used:
●
DS-CAL1 v1
●
DS-CAL1 v3
Please see chapter DS-CAL test board, to distinguish between different DS-CAL test board versions.
DS-CAN2 must be connected to the calibration system along with the Dewesoft UUT according to the
Table 9.
DS-CAN2
Connection description
Power
Not connected.
USB
Connects to the PC performing calibration
procedure.
CAN1
Connects to CAN1 connector of the CAN Y-cable
and the other end to the DS-CAL test board.
CAN2
Connects to CAN2 connector of the CAN Y-cable.
Table 9: DS-CAN2 connection description
Illustration 21: Sirius USB UUT connections
DS-CAL V20-1
31/67