DETEWE OpenPhone 26, User Manual

Page: 38 / 116

Telephoning General Information
36
3.1.19 “Selection” Menu in the Idle State
Note: Menu items marked with an * are only displayed if the
corresponding user authorisation has been set in the Config-
urator.
Press the Menu softkey briefly (this is also possible when you have already pressed
the receiver key
A
), and then select …
Unpark call
: Consecutively unparks one or more connections which you have
previously parked, for instance to make enquiries or to forward calls (see
“Calling …” Menu starting on page 44).
Redial
: The list of the last dialled numbers is displayed and you can dial one of
these numbers again. This menu point is only displayed with an OpenPhone 26.
Phone book
: You open the OpenCom 100 telephone book. You can enter new
entries, edit existing entries or call one of the stored subscribers. This menu point
is only displayed with an OpenPhone 26.
Pick-up
:* You pick up a call made to another telephone in your pick-up group.
Pick-up select.
:* Once you have entered the telephone number, you can pick
up a call to any other telephone. If the other telephone is in the call state (e. g. an
answering machine is making an announcement), you pick up the call. The sub-
scriber for whom you picked up the call must belong to a user group for which
“Call removal” authorisation is activated, otherwise “Pick-up selective” is not pos-
sible.
Note: If the called subscriber is a member of a user group
for which pick-up protection is active, “Pick-up” and “Pick-up
selective” are not possible.
Announcement
:* Once you have entered the telephone number, you can initiate
an announcement to another system terminal (or on a group of system ter-
minals).
Intercom
: After entering the device ID, you can initiate an announcement to a
single system terminal. The microphone of the end terminal called will be
switched on and the person you are calling can immediately answer your
announcement. The “Intercom” function cannot be used for announcements to a
group of terminals.