10
COMPRESSOR USER MANUAL
866-DTE-INFO
dentalez.com
PN: 7717-004A
FEET KIT
TOOLS REQUIRED
7/16" Wrench
1/2" Wrench
PARTS INCLUDED
Foot (4 Pieces)
Flanged Nut (4 Pieces)
WARNING
Prior to starting this assembly, read, understand and follow the safety information and the assembly instructions in
this user manual.
Handles for lifting the compressor assembly are provided on each end of the device. Lifting the compressor
assembly by any other part or location could result in damage to the compressor.
The weight distribution of this compressor is unbalanced to the front of the device. Exercise care when lifting to
avoid accidental tipping and possible dropping of the device, which could result in damage to the compressor or
severe injuries to the installer.
Compressor assemblies are very heavy and may require multiple people to safely lift. Prior to lifting, check the user
manual for the weight of this model. Over-exertion could result in serious injuries to the installer.
This procedure may not comply with all safety requirements of federal, state or local agencies or safety
requirements of the installer’s employer. If a conflict does exist, follow the requirements set forth by the other
organizations.
ASSEMBLY
1.
Remove the four nuts (7/16" wrench) from the bolts that
secure the Aeras compressor legs to the wooden shipping
pallet. At this point, the bolts can be removed from the legs
and the compressor can be removed from the pallet. Do
not attempt to install the feet while the compressor is on the
pallet; tipping of the pallet and subsequent loss of control
may occur.
2. Lift one end of the compressor using the integrated handles
and place blocking under the end of the tank to support the
compressor. Be careful not to damage the drain valve under
the center of the tank. Never work under a compressor that
is not supported with adequate blocking
(FIGURE 3)
.
FIGURE 3. BLOCK THE COMPRESSOR TANK
TO INSTALL FEET
FOOT (4)
FLANGED NUT (4)
SECTION III - INSTALLATION
(Continued on the next page.)
