11
FIGURE 4. INSTALL FLANGED NUT
FEET KIT (CONTINUED)
3. Thread feet into the two elevated legs from the
bottom side of the leg.
4. Adjust each foot to approximately the same height,
then thread a flanged nut (flange side toward the leg)
onto each foot
(FIGURE 4)
.
NOTE:
It is not necessary to tighten the flanged nuts at
this time. The feet will require further adjustment once
the compressor has been placed in its permanent
location in the utility room.
5. Lift the compressor and remove the blocking from
under the tank end. Repeat steps 2 through 4 for the
opposite end of the compressor.
6. After the compressor is in its permanent location in the utility room, adjust each foot using a 7/16" wrench until the
compressor is setting level. After adjusting the feet, tighten the flanged nut with a 1/2" wrench to lock the foot into
position.
FILTER DRAIN KIT
PARTS INCLUDED
Drain Hose
Elbow Fitting
WARNING
Prior to starting this assembly, read, understand and follow the safety
information and the assembly instructions in this user manual.
The bowl on the coalescing filter assembly is under high pressure while
the system is running. Allow the compressor to stop running and release
the pressure prior to removing the bowl. Failure to allow the system to
properly de-pressurize could result in severe injuries.
Always disconnect the compressor from the electrical power source
prior to conducting any maintenance or service of the equipment. The
compressor could start unexpectedly, resulting in possible injury to the service technician.
This procedure may not comply with all safety requirements of federal, state or local agencies or safety
requirements of the installer’s employer. If a conflict does exist, follow the requirements set forth by the other
organizations.
SECTION III - INSTALLATION
ELBOW
FITTING
DRAIN
HOSE
(Continued from the previous page.)
