SunScan User Manual v 1.05
Appendices
••••
79
♦
From the Psion System Screen, press
Menu, Disk, Directory, Enter
.
♦
Press
←
←
←
←
→
→
→
→
to select the Disk Internal, (or any other Disks or drives).
Note: the Workabout refers to its own drives as
Internal
and
Disk A, B, C
etc . The
drives on the PC are referred to as
REM::A:, REM::C:
(
REM
= remote).
If no subdirectory
\SUN\
exists, then create one as follows:
♦
Select
\
, the root directory of the Disk Internal
♦
Press
Menu, Directory, Make directory, Enter
.
♦
For Dir. Name type
\SUN
and press
Enter
.
♦
Access the directories again with
Menu, Disk, Directory, Enter
.
The new subdirectory
\SUN\
will now be listed under the root directory of the
Internal Disk.
♦
Now press
←
←
←
←
→
→
→
→
to move to the
REM::C:
drive (your PC's hard disk) and enter the
\SUNSCAN\PSION
directory.
♦
Press
↑↑↑↑
or
↓↓↓↓
to highlight the file
Sundata.app
.
Don't
press
Enter
!
♦
Press
Menu, File, Copy file, Enter
.
♦
Complete the dialog box as shown below, noting the general advice.
♦
Press
Enter
to accept, when you are happy with all the details.
The Workabout will warn you if you have chosen a filename that already exists, and
offer you various options. Otherwise it will proceed, and briefly advise you of the
copying process.
A copy of the file is now in the new location you have specified.
You must also copy across the file
Sys$8087.ldd
to the same directory on the
Workabout, for the SunData program to run properly. You can do this by a similar
procedure. Finally:
♦
On your PC, quit the
SLINK
program by typing
Q
.
♦
On the Workabout, close down the Remote Link: From the System Screen, press
Menu, Spec, Remote Link
, and set it to
Off
,
then press
Enter.
If the SunData icon does not automatically appear in the Psion System screen, see
More Psion and file handling notes
about re-installing SunData as an application.
You must specify the full
subdirectory path of the Disk. Start
and finish with backslashes(\).
If you leave the filename blank after
the backslash, the original filename
will be used. If you want to change
the filename, type in the new
filename, with its extension, after the
directory path.
