Dell Z9000, Configuration Manual

Page: 210 / 968

For inbound and outbound updates the order of preference is:
• prefix lists (using the
neighbor distribute-list
command)
• AS-PATH ACLs (using the
neighbor filter-list
command)
• route maps (using the
neighbor route-map
command)
Prior to filtering BGP routes, create the prefix list, AS-PATH ACL, or route map.
For configuration information about prefix lists, AS-PATH ACLs, and route maps, refer to Access Control
Lists (ACLs) .
NOTE: When you configure a new set of BGP policies, to ensure the changes are made, always
reset the neighbor or peer group by using the
clear ip bgp
command in EXEC Privilege mode.
To filter routes using prefix lists, use the following commands.
1. Create a prefix list and assign it a name.
CONFIGURATION mode
ip prefix-list prefix-name
2. Create multiple prefix list filters with a deny or permit action.
CONFIG-PREFIX LIST mode
seq sequence-number {deny | permit} { any | ip-prefix [ge | le] }
•
ge
: minimum prefix length to be matched.
•
le
: maximum prefix length to me matched.
For information about configuring prefix lists, refer to Access Control Lists (ACLs) .
3. Return to CONFIGURATION mode.
CONFIG-PREFIX LIST mode
exit
4. Enter ROUTER BGP mode.
CONFIGURATION mode
router bgp as-number
5. Filter routes based on the criteria in the configured prefix list.
CONFIG-ROUTER-BGP mode
neighbor { ip-address | peer-group-name } distribute-list prefix-list-name {in
| out}
Configure the following parameters:
•
ip-address
or
peer-group-name
: enter the neighbor’s IP address or the peer group’s name.
•
prefix-list-name
: enter the name of a configured prefix list.
•
in
: apply the prefix list to inbound routes.
•
out
: apply the prefix list to outbound routes.
As a reminder, the following are rules concerning prefix lists:
210
Border Gateway Protocol IPv4 (BGPv4)