Dell S4048T, Configuration Manual

Page: 914 / 1277

exit Exit from the EXEC
no Negate a command
show Show running system information
terminal Set terminal line parameters
traceroute Trace route to destination
Dell#confi
Dell(conf)#?
end Exit from Configuration mode
exit Exit from Configuration mode
no Reset a command
snmp-server Modify SNMP parameters
Dell(conf)#
Specifying LINE Mode Password and Privilege
You can specify a password authentication of all users on different terminal lines.
The user’s privilege level is the same as the privilege level assigned to the terminal line, unless a more specific
privilege level is assigned to the user.
To specify a password for the terminal line, use the following commands.
• Configure a custom privilege level for the terminal lines.
LINE mode
privilege level level
•
level level
: The range is from 0 to 15. Levels 0, 1, and 15 are pre-configured. Levels 2 to 14 are
available for custom configuration.
• Specify either a plain text or encrypted password.
LINE mode
password [ encryption-type ] password
Configure the following optional and required parameters:
•
encryption-type
: Enter 0 for plain text or 7 for encrypted text.
•
password
: Enter a text string up to 32 characters long.
To view the password configured for a terminal, use the
show config
command in LINE mode.
Enabling and Disabling Privilege Levels
To enable and disable privilege levels, use the following commands.
• Set a user’s security level.
EXEC Privilege mode
enable
or
enable privilege-level
If you do not enter a privilege level, Dell Networking OS sets it to 15 by default.
• Move to a lower privilege level.
EXEC Privilege mode
disable level-number
Security 914