Dell S4048T, Configuration Manual

Page: 493 / 1277

Dynamic Counters
By default, counting is enabled for IPFLOW, IPACL, L2ACL, L2FIB.
For the remaining applications, Dell Networking OS automatically turns on counting when you enable the
application, and is turned off when you disable the application.
NOTE: If you enable more than four counter-dependent applications on a port pipe, there is an impact on
line rate performance.
The following counter-dependent applications are supported by Dell Networking OS:
• Egress VLAN
• Ingress VLAN
• Next Hop 2
• Next Hop 1
• Egress ACLs
• ILM
• IP FLOW
• IP ACL
• IP FIB
• L2 ACL
• L2 FIB
Clearing Interface Counters
The counters in the
show interfaces
command are reset by the
clear counters
command. This
command does not clear the counters any SNMP program captures.
To clear the counters, use the following the command.
• Clear the counters used in the
show interface
commands for all VRRP groups, VLANs, and physical
interfaces or selected ones. Without an interface specified, the command clears all interface counters.
EXEC Privilege mode
clear counters [ interface ] [vrrp [ vrid ] | learning-limit]
(OPTIONAL) Enter the following interface keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port[/
subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For a Loopback interface, enter the keyword
loopback
then a number from 0 to 16383.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet
then the
slot/port information.
• For a port channel interface, enter the keywords
port-channel
then a number.
• For a VLAN interface, enter the keyword
vlan
then a number from 1 to 4094.
Interfaces 493