Dell S4048T, Configuration Manual

Page: 610 / 1277

Configuring FEFD
You can configure FEFD for all interfaces from CONFIGURATION mode, or on individual interfaces from
INTERFACE mode.
To enable FEFD globally on all interfaces, use the following command.
• Enable FEFD globally on all interfaces.
CONFIGURATION mode
fefd-global
To report interval frequency and mode adjustments, use the following commands.
1 Setup two or more connected interfaces for Layer 2 or Layer 3.
INTERFACE mode
ip address ip address , switchport
2 Enable the necessary ports administratively.
INTERFACE mode
no shutdown
3 Enable fefd globally.
CONFIGURATION mode
fefd-global {interval | mode}
Example of the
show fefd
Command
To display information about the state of each interface, use the
show fefd
command in EXEC privilege
mode.
Dell#show fefd
FEFD is globally 'ON', interval is 3 seconds, mode is 'Normal'.
INTERFACE MODE INTERVAL STATE
(second)
Te 1/1 Normal 3 Bi-directional
Te 1/2 Normal 3 Admin Shutdown
Te 1/3 Normal 3 Admin Shutdown
Te 1/4 Normal 3 Admin Shutdown
Dell#show run fefd
!
fefd-global mode normal
fefd-global interval 3
Layer 2 610