Dell S4048T, Configuration Manual

Page: 769 / 1277

Defined as:
seq 5 permit ip 200.200.200.200 200.200.200.200 199.199.199.199 199.199.199.199
seq 10 redirect 1.1.1.2 tcp 234.224.234.234 255.234.234.234 222.222.222.222/24
seq 40 ack, Next-hop reachable(via Te 8/1)
Applied interfaces:
Te 8/2
Hot-Lock PBR
Ingress and egress Hot lock PBR allows you to add or delete new rules into an existing policy (already written
into content address memory [CAM]) without disruption to traffic flow. Existing entries in content addressable
memory (CAM) are adjusted to accommodate the new entries. Hot Lock PBR is enabled by default.
Configuration Task List for Policy-based
Routing
This section explains how to configure PBR on the system.
• Create a Redirect List
• Create a Rule for a Redirect-list
• Create a Track-ID list
• Apply a Redirect-list to an Interface using a Redirect-group
PBR Exceptions (Permit)
To create an exception to a redirect list, use the
permit
command. Exceptions are used when a forwarding
decision should be based on the routing table rather than a routing policy.
The Dell Networking OS assigns the first available sequence number to a rule configured without a sequence
number and inserts the rule into the PBR CAM region next to the existing entries. Because the order of rules is
important, ensure that you configure any necessary sequence numbers.
Never apply the
permit
statement because the redirect list covers all source and destination IP addresses.
ip redirect-list rcl0
seq 5 redirect 2.2.2.2 ip any any
seq 10 permit ip host 3.3.3.3 any
To ensure the
permit
permit statement or PBR exception is effective, use a lower sequence number, as
shown:
ip redirect-list rcl0
seq 10 permit ip host 3.3.3.3 any
seq 15 redirect 2.2.2.2 ip any any
Policy-based Routing (PBR) 769