Dell S4048T, Configuration Manual

Page: 560 / 1277

Enter the keyword
interface
then the type of interface and slot/port information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port[/
subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For a Loopback interface, enter the keyword
loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords
port-channel
then a number.
• For a VLAN interface, enter the keyword
vlan
then a number from 1 to 4094.
4 Enter an IPv4 Address.
INTERFACE mode
ip address ip-address mask
Assign an IP address and mask to the interface.
The IP address must be on the same subnet as other IS-IS neighbors, but the IP address does not need
to relate to the NET address.
5 Enter an IPv6 Address.
INTERFACE mode
ipv6 address ipv6-address mask
•
ipv6 address
: x:x:x:x::x
•
mask
: The prefix length is from 0 to 128.
The IPv6 address must be on the same subnet as other IS-IS neighbors, but the IP address does not
need to relate to the NET address.
6 Enable IS-IS on the IPv4 interface.
ROUTER ISIS mode
ip router isis [ tag ]
If you configure a tag variable, it must be the same as the
tag
variable assigned in step 1.
7 Enable IS-IS on the IPv6 interface.
ROUTER ISIS mode
ipv6 router isis [ tag ]
If you configure a tag variable, it must be the same as the
tag
variable assigned in step 1.
Examples of the
show isis
Commands
The default IS type is level-1-2 . To change the IS type to Level 1 only or Level 2 only, use the
is-type
command in ROUTER ISIS mode.
To view the IS-IS configuration, enter the
show isis protocol
command in EXEC Privilege mode or the
show config
command in ROUTER ISIS mode.
Dell#show isis protocol
IS-IS Router: <Null Tag>
System Id: EEEE.EEEE.EEEE IS-Type: level-1-2
Manual area address(es):
47.0004.004d.0001
Routing for area address(es):
Intermediate System to Intermediate System 560