Dell S4048T, Configuration Manual

Page: 407 / 1277

• All VLANS must be in Layer 2 mode.
• Tag control VLAN ports. Member VLAN ports, except the Primary/Secondary interface, can be tagged or
untagged.
• The control VLAN must be the same for all nodes on the ring.
To create the Members VLANs for this FRRP group, use the following commands on all of the Transit switches
in the ring.
1 Create a VLAN with this ID number.
CONFIGURATION mode.
interface vlan vlan-id
VLAN ID: the range is from 1 to 4094.
2 Tag the specified interface or range of interfaces to this VLAN.
CONFIG-INT-VLAN mode.
tagged interface { range }
Interface
:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port[/
subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
3 Assign the Primary and Secondary ports and the Control VLAN for the ports on the ring.
CONFIG-FRRP mode.
interface primary interface secondary interface control-vlan vlan id
Interface
:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port[/
subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
VLAN ID
: Identification number of the Control VLAN.
4 Configure a Transit node.
CONFIG-FRRP mode.
mode transit
5 Identify the Member VLANs for this FRRP group.
CONFIG-FRRP mode.
member-vlan vlan-id { range }
VLAN-ID, Range
: VLAN IDs for the ring’s Member VLANs.
6 Enable this FRRP group on this switch.
CONFIG-FRRP mode.
no disable
Force10 Resilient Ring Protocol (FRRP) 407