Dell S4048T, Configuration Manual

Page: 59 / 1277

225 bytes successfully copied
Dell#
Save the Running-Configuration
The running-configuration contains the current system configuration. Dell Networking recommends coping
your running-configuration to the startup-configuration.
The commands in this section follow the same format as those commands in the
Copy Files to and from the System section but use the filenames startup-configuration and running-
configuration. These commands assume that current directory is the internal flash, which is the system
default.
• Save the running-configuration to the startup-configuration on the internal flash of the primary RPM.
EXEC Privilege mode
copy running-config startup-config
• Save the running-configuration to an FTP server.
EXEC Privilege mode
copy running-config ftp: // username:password@{hostip | hostname}/filepath/
filename
• Save the running-configuration to a TFTP server.
EXEC Privilege mode
copy running-config tftp: //{hostip | hostname}/ filepath/filename
• Save the running-configuration to an SCP server.
EXEC Privilege mode
copy running-config scp: //{hostip | hostname}/ filepath/filename
NOTE: When copying to a server, a host name can only be used if a DNS server is configured.
Configure the Overload Bit for a Startup
Scenario
For information about setting the router overload bit for a specific period of time after a switch reload is
implemented, see the Intermediate System to Intermediate System (IS-IS) section in the Dell Command Line
Reference Guide for your system.
Viewing Files
You can only view file information and content on local file systems.
To view a list of files or the contents of a file, use the following commands.
• View a list of files on the internal flash.
EXEC Privilege mode
dir flash:
Getting Started 59