Dell S4048T, Configuration Manual

Page: 875 / 1277

Configuration Task List
The following is the configuration task list for RIP.
• Enabling RIP Globally (mandatory)
• Configure RIP on Interfaces (optional)
• Controlling RIP Routing Updates (optional)
• Setting Send and Receive Version (optional)
• Generating a Default Route (optional)
• Controlling Route Metrics (optional)
• Summarize Routes (optional)
• Controlling Route Metrics
• Debugging RIP
For a complete listing of all commands related to RIP, refer to the Dell Networking OS Command Reference
Interface Guide .
Enabling RIP Globally
By default, RIP is not enabled in Dell Networking OS.
To enable RIP globally, use the following commands.
1 Enter ROUTER RIP mode and enable the RIP process on Dell Networking OS.
CONFIGURATION mode
router rip
2 Assign an IP network address as a RIP network to exchange routing information.
ROUTER RIP mode
network ip-address
Examples of Verifying RIP is Enabled and Viewing RIP Routes
After designating networks with which the system is to exchange RIP information, ensure that all devices on
that network are configured to exchange RIP information.
The Dell Networking OS default is to send RIPv1 and to receive RIPv1 and RIPv2. To change the RIP version
globally, use the
version
command in ROUTER RIP mode.
To view the global RIP configuration, use the
show running-config
command in EXEC mode or the
show
config
command in ROUTER RIP mode.
Dell(conf-router_rip)#show config
!
router rip
network 10.0.0.0
Dell(conf-router_rip)#
Routing Information Protocol (RIP) 875