User Diagnostics for Windows NIC Driver Management Applications: QLogic QME8242 Mezzanine Card User's Guide
file:///T|/htdocs/NETWORK/QLogic/71922/en/diag_win.htm[9/26/2012 4:26:06 PM]
qaucli -nic [options]
Use NIC legacy command line
netscli [options]
Use NIC legacy command line
qaucli iscsi [options]
Use iSCSI legacy command line
iscli [options]
Use iSCSI legacy command line
qaucli -fc [options]
Use Fibre Channel legacy command line
scli [options]
Use Fibre Channel legacy command line
Diagnostic help commands, and command options available for each specific protocol, are available by specifying -h to the
protocol, as shown in
Table 3
.
Table 3. Windows QConvergeConsole CLI—Getting Help
Command
Description
-h
Print usage of a specific adapter type, and then exit
qaucli -pr nic -h
Print NIC protocol usage, and then exit
qaucli -pr fc -h
Print Fibre Channel and FCoE protocol usage, and then
exit
qaucli -pr iscsi -h
Print iSCSI protocol usage, and then exit
qaucli -npar -h
Print NPAR commands usage, and then exit
Table 4
lists miscellaneous Windows diagnostics commands.
Table 4. Windows QConvergeConsole CLI—Miscellaneous Commands
Command
Description
qaucli -v
Print version number, and then exit
qaucli -h
Print usage, and then exit
Table 5
lists the Windows CLI diagnostic test commands. Note that while running these tests, network traffic is interrupted.
Table 5. Windows QConvergeConsole CLI—Diagnostic Test Commands
Command
Description
-i
--interface
Specifies the interface type (NX_NIC, NX_NIC1, and so on)
-a
--all
Perform all test, regardless of default
-D
--default
Perform only default test
-R
--CRegs
Test all control registers (default)
-I
--IRQS
Test interrupt mechanism (default)
-L
--IntLB
Internal loopback test (default)
-H
--Hw
Hardware test (default)
-S
Link status test (default)
