Dell Precision Workstation 530, User Manual

Page: 116 / 300

116
Removing and Installing Parts
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
4
Press the lever on the expansion card retention arm and raise the
retention arm (see " Raising the Expansion Card Retention Arm ").
5
If necessary, disconnect any cables connected to the card.
6
Grasp the card by its top corners, and ease it out of its connector.
7
If you are removing the card permanently, install a filler bracket in the
empty card-slot opening.
If you need a filler bracket, contact Dell and order part number 81808.
NOTE: Installing filler brackets over empty card-slot openings is
necessary to maintain FCC certification of the computer. The brackets
also keep dust and dirt out of your computer.
8
Lower the expansion card retention arm and press it into place,
securing the expansion card(s) in the chassis.
9
Close the computer cover .
10
Stand the computer upright.
11
Reconnect the computer and devices to their electrical outlets, and
turn them on.
NOTE:
If enabled, the
Chassis Intrusion
option will cause the following
message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
12
If you removed a sound card, perform the following steps:
a
Enter system setup , select Integrated Devices and change the
setting for Sound to On .
b
Connect external audio devices to the audio connectors on the
computer back panel (see " Back-Panel Features ").
13
If you removed an add-in network adapter, perform the following steps:
a
Enter system setup , select Integrated Devices and change the
setting for Network Interface Card to On .
b
Connect the network cable to the integrated connector on the
computer back panel (see " Back-Panel Features ").