Dell PowerEdge 4200 Series, Administrator'S Manual

Page: 359 / 440

Configuring the SRA Appliance with a Third-Party Gateway | 359
Appendix B
Configuring the SRA Appliance with a
Third-Party Gateway
This appendix shows methods for configuring various third-party firewalls for deployment with
a SRA appliance.
This appendix contains the following sections:
•
“Cisco PIX Configuration for SRA Appliance Deployment” section on page 359
•
“Linksys WRT54GS” section on page 365
•
“WatchGuard Firebox X Edge” section on page 365
•
“NetGear FVS318” section on page 367
•
“Netgear Wireless Router MR814 SSL configuration” section on page 369
•
“Check Point AIR 55” section on page 370
Cisco PIX Configuration for SRA Appliance
Deployment
Before you Begin
Make sure you have a management connection to the PIX’s console port, or the ability to Telnet/
SSH into one of the PIX’s interfaces. You will need to know the PIX’s global and enable-level
passwords in order to access the device and issue changes to the configuration. If you do not
have these, contact your network administrator before continuing.
Dell SonicWALL recommends updating the PIX’s OS to the most recent version if your PIX can
support it. This document was validated on a Cisco PIX 515e running PIX OS 6.3.5 and is the
recommended version for interoperation with a SRA appliance. You will need a valid Cisco
SmartNET maintenance contract for your Cisco PIX and a CCO login to obtain newer versions
of the PIX OS.
Note The WAN/DMZ/LAN IP addresses used in the deployment method examples below are not
valid and will need to be modified to reflect your networking environment.
Management Considerations for the Cisco Pix
Both deployment methods described below use the PIX’s WAN interface IP address as the
means of external connectivity to the internal SRA appliance. The PIX has the ability to be
managed via HTTP/S, but cannot have their default management ports (80,443) reassigned in