Selecting the Operation Code Start-up File
1.
In the
Start-Up Operation Code Image File
field, select the start-up code file from the drop-down menu.
2.
Click
Apply Changes
.
The following table summarizes the equivalent CLI commands for items in the
Switch/Firmware
page.
Example
Console#copy tftp file
TFTP server ip address: 10.1.0.45
Choose file type:
1. config: 2. opcode: <1-2>: 2
Source file name: runtime
Destination file name: 0126.bix
/
Console#
Configuration
From the
Configuration
page you can save and restore switch configuration settings.
The
Configuration
page contains the following editable fields:
l
Transfer Configuration to Server
—
Copies a switch configuration file to a TFTP server.
l
Transfer Configuration from Server
—
Copies a switch configuration file from a TFTP server.
l
Remove Configuration File
—
Deletes a configuration file from the switch (selected from the drop-down menu).
l
Start-Up Configuration File
—
Selects the configuration file to be used after a system start-up (selected from the drop-down menu).
l
Copy Running Config to File
—
Saves the current session configuration settings. Specifies a new filename or the name of an existing file to be replaced.
Transferring a Configuration File to a Server
1.
In the
Transfer Configuration File to Server
field, enter the IP address of the TFTP server in the
TFTP Server IP Address
field.
Command
Usage
copy tftp file
Downloads a code image to the switch's flash memory from a
TFTP server
boot system {boot-rom | config | opcode}:
filename
Specifies the file or image used to start up the system
dir [boot-rom | config | opcode [:
filename
]]
Displays a list of files in flash memory
NOTE:
You cannot upload and download Boot-ROM files to a TFTP server using the CLI. You must use a direct terminal connection to the switch's
console port and press <Ctrl><f> after the diagnostic test results. See "
Downloading Firmware Through the Console Port
."
NOTE:
The switch is shipped with one default configuration file (
Factory_Default_
Config.cfg
) installed, which is set as the start- up file. This file cannot be removed from the system.
NOTICE:
For configuration changes to persist beyond the current session, you must save the
running-config
file from this page, or use the CLI
command
copy running-config startup-config
.
