configuration.
6.
Attach the new drive to the drive bracket.
Turn the drive upside down, and fit the bracket on the drive so that the screw holes align. To ensure proper installation, all screw holes should be
aligned and the tabs on the front of the bracket should be flush with the front of the drive (see the following figure).
Attaching the Drive Bracket to the New Drive
To further ensure proper positioning of the drive in the chassis, insert and tighten all four screws
in the order in which the holes are numbered
(the holes
are marked "1" through "4").
7.
Slide the new drive/bracket assembly into the drive bay until both drive bracket tabs snap securely into place (see the following figure).
Installing the Drive Bracket in the Chassis
8.
Connect the interface cable for the drive (see "
Attaching Drive Cables in the Chassis
").
a.
If you are installing an enhanced integrated drive electronics (EIDE) device, make sure that the interface cable is properly connected to the EIDE
connector on the system board. For more information, see "
EIDE Device Installation Guidelines
."
b.
If you are installing a small computer system interface (SCSI) device, make sure that the SCSI interface cable is properly connected to the
interface connector on the SCSI controller board. For more information, see "
SCSI Device Installation Guidelines
."
9.
Connect a DC power cable to the power input connector on the back of the drive (see the following figure).
NOTICE:
To avoid possible damage, you must match the colored strip on the interface cable with pin 1 on both the drive and system board connectors.
