AGP Graphics Card/GPA (AIMM) Card
To install an AGP graphics card, perform the following steps.
1.
Open the computer cover
.
2. Remove the filler bracket (see the
back panel
for the location of the filler bracket [AGP slot]) by raising the hinged lever and sliding the
bracket up.
On the small desktop computer, press the indented tab with your thumb at an angle toward the system board until you release the tab.
Continue holding the lever and pull the lever up.
Removing the AGP Slot Filler Bracket in the Small Form-Factor Desktop System
Removing the AGP Slot Filler Bracket in the Small Desktop System
Removing the AGP Slot Filler Bracket in the Small Mini
-Tower System
1
Securing clips (2)
CAUTION: To avoid the possibility of electric shock, turn off the computer and any peripherals, disconnect them from their
electrical outlets, and then wait at least 5 seconds before you open the computer cover. Also, before you upgrade memory,
see the other precautions in "
Safety Information
."
NOTE:
The small form-factor and small desktop systems support low-profile AGP cards.
1
Hinged lever
1
Hinged lever
2
Indented tab
Summary of Contents for OptiPlex GX150
Page 2: ...February 2002 08WUP A06 ...
Page 97: ...Back to Contents Page ...
