Dell Force10 TeraScale C Series, Reference Manual

Page: 710 / 1640

710 | IPv6 Access Control Lists (IPv6 ACLs)
www.dell.com | support.dell.com
IPv6 Route Map Commands
The following commands allow you to configure route maps and their redistribution criteria.
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• route-map
• set ipv6 next-hop
• show config
• show route-map
match ipv6 address
c e s
Configure a filter to match routes based on IPv6 addresses specified in an access list.
Syntax match ipv6 address prefix-list-name
To delete a match, use the no match ipv6 address prefix-list-name command.
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Related
Commands
match ipv6 next-hop
c e s
Configure a filter which matches based on the next-hop IPv6 addresses specified in the IPv6 prefix list.
Syntax match ipv6 next-hop prefix-list prefix-list-name
To delete a match, use the
no match ipv6 next-hop prefix-list prefix-list-name
command.
Parameters
prefix-list-name Enter the name of IPv6 prefix list, up to 140 characters.
Version 8.4.2.1 Introduced on the S-Series
Version 8.2.1.0 Introduced support on the E-Series ExaScale
Version 7.8.1.0 Introduced support on the C-Series
Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16
characters long.
Version 7.4.1.0 Introduced support on the E-Series TeraScale
match ipv6 next-hop Redistribute routes that match the next-hop IP address.
match ipv6 route-source Redistribute routes that match routes advertised by other routers.
prefix-list
prefix-list-name
Enter the keywords
prefix-list
followed by the name of configured prefix
list, up to 140 characters.