Dell Force10 TeraScale C Series, Reference Manual

Page: 657 / 1640

IPv4 Routing | 657
Usage
Information
When a static route (or a protocol route) overlaps with Management static route, the static route (or a
protocol route) is preferred over the Management Static route. Also, Management static routes and the
Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables
are maintained for IPv4 and IPv6 management routes. This command manages both tables.
Related
Commands
show arp
c e s
Display the ARP table.
Syntax show arp [vrf
vrf name
]
[
interface interface
|
ip ip-address
[
mask
] |
macaddress
mac-address
[
mac-address mask
]] [
cpu
{
cp
|
rp1
|
rp2
}] [
static
|
dynamic
] [
summary
]
Parameters
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
interface ManagementEthernet Configure the Management port on the system (either the Primary or
Standby RPM).
duplex (Management) Set the mode of the Management interface.
speed (Management interface) Set the speed for the Management interface.
vrf name
E-Series Only : Show only the ARP cache entries tied to the VRF process.
cpu
(OPTIONAL) Enter the keyword
cpu
with one of the following keywords to
view ARP entries on that CPU:
•
cp
- view ARP entries on the control processer.
•
rp1
- view ARP entries on Routing Processor 1.
•
rp2
- view ARP entries on Routing Processor 2.
interface interface (OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For the Management interface, enter the keyword
managementethernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel
followed
by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512
for ExaScale.
• For a SONET interface, enter the keyword
sonet
followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN, enter the keyword
vlan
followed by a number from 1 to 4094.
ip ip-address mask
(OPTIONAL) Enter the keyword
ip
followed by an IP address in the dotted
decimal format. Enter the optional IP address mask in the slash prefix format (/
x).
macaddress
mac-address mask
(OPTIONAL) Enter the keyword
macaddress
followed by a MAC address in
nn:nn:nn:nn:nn:nn format. Enter the optional MAC address mask in
nn:nn:nn:nn:nn format also.
static
(OPTIONAL) Enter the keyword
static
to view entries entered manually.