Dell Force10 TeraScale C Series, Reference Manual

Page: 1089 / 1640

Policy-based Routing (PBR) | 1089
redirect
c e s
Configure a rule for the redirect list.
Syntax redirect { ip-address | sonet slot/port } { ip-protocol-number | protocol-type [ bit ]} { source mask
| any | host ip-address } { destination mask | any | host ip-address } [ operator ]
To remove this filter, use one of the following:
• Use the no seq sequence-number command syntax if you know the filter’s sequence number.
• Use the no redirect { ip-address | sonet slot/port } { ip-protocol-number [ bit ] | protocol-type }
{ source mask | any | host ip-address } { destination mask | any | host ip-address }
[ operator ]
Parameters
Defaults
No default behavior or values
Command Modes
REDIRECT-LIST
ip-address
Enter the IP address of the forwarding router.
sonet slot/port
Enter the keyword
sonet
followed by the slot/port information.
ip-protocol-number Enter a number from 0 to 255 for the protocol identified in the IP protocol
header.
protocol-type Enter one of the following keywords as the protocol type:
•
icmp
for Internet Control Message Protocol
•
ip
for Any Internet Protocol
•
tcp
for Transmission Control Protocol
•
udp
for User Datagram Protocol
bit (OPTIONAL) For TCP protocol type only, enter one or a combination of the
following TCP flags:
•
ack
= acknowledgement
•
fin
= finish (no more data from the user)
•
psh
= push function
•
rst
= reset the connection
•
syn
= synchronize sequence number
•
urg =
urgent field
source
Enter the IP address of the network or host from which the packets were sent.
mask
Enter a network mask in /prefix format (/x).
any
Enter the keyword
any
to specify that all traffic is subject to the filter.
host ip-address
Enter the keyword
host
followed by the IP address to specify a host IP
address.
destination Enter the IP address of the network or host to which the packets are sent.
operator (OPTIONAL) For TCP and UDP parameters only. Enter one of the
following logical operand:
•
eq
= equal to
•
neq
= not equal to
•
gt
= greater than
•
lt
= less than
•
range
= inclusive range of ports (you must specify two ports for the
port
command parameter.)