Dell Force10 TeraScale C Series, Reference Manual

Page: 353 / 1640

Border Gateway Protocol IPv4 (BGPv4) | 353
Related
Commands
Command
History
neighbor remote-as
c e s
Create and specify the remote peer to the BGP neighbor.
Syntax neighbor { ip-address | peer-group-name } remote-as number
To delete a remote AS entry, use the no neighbor { ip-address | peer-group-name } remote-as
number command.
Parameters
Defaults Not configured.
Command Modes ROUTER BGP
Usage
Information
You must configure your system to accept 4-Byte formats before entering a 4-Byte AS Number. If the
number parameter is the same as the AS number used in the router bgp command, the remote AS entry
in the neighbor is considered an internal BGP peer entry.
This command creates a peer and the newly created peer is disabled (shutdown).
Related
Commands
Command
History
neighbor remove-private-as
c e s
Remove private AS numbers from the AS-PATH of outgoing updates.
Syntax neighbor
{
ip-address
|
peer-group-name
}
remove-private-as
To return to the default, use the
no neighbor
{
ip-address
|
peer-group-name
}
remove-private-as
command.
neighbor soft-reconfiguration inbound Assign a subnet to a dynamically-configured BGP neighbor.
Version 8.4.2.0 Added support for the match-af keyword
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address Enter the IP address of the neighbor to enter the remote AS in its routing table.
peer-group-name
Enter the name of the peer group to enter the remote AS into routing tables of all
routers within the peer group.
number
Enter a number of the AS.
Range: 0-65535 (2-Byte) or 1-4294967295 (4-Byte)
router bgp Enter the ROUTER BGP mode and configure routes in an AS.
bgp four-octet-as-support Enable 4-Byte support for the BGP process.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Added 4-Byte support.