Dell Force10 TeraScale C Series, Reference Manual

Page: 614 / 1640

614 | Interfaces
www.dell.com | support.dell.com
speed (Management interface)
c e
Set the speed for the Management interface.
Syntax speed { 10 | 100 | auto }
To return to the default setting, use the no speed { 10 | 100 } command.
Parameters
Defaults auto
Command Modes
INTERFACE
Command
History
Usage
Information
This command is found on the Management interface only.
Related
Commands
switchport
c e s
Place an interface in Layer 2 mode.
Syntax switchport
[
backup interface
{
gigabit slot/port | tengigabit slot/port | port-channel
number
}]
To remove an interface from Layer 2 mode and place it in Layer 3 mode, enter
no switchport
. If a
switchport backup interface is configured, you must first remove the backup configuration. To remove
a switchport backup interface, enter
no switchport backup interface
{
gigabit slot/port |
tengigabit slot/port | port-channel number
}].
Parameters
10
Enter the keyword
10
to set the interface’s speed to 10 Mb/s.
100
Enter the keyword
100
to set the interface’s speed to 100 Mb/s.
auto
Enter the keyword
auto
to set the interface to auto-negotiate its speed.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.0 Introduced for E-Series
interface ManagementEthernet Configure the Management port on the system (either the Primary or
Standby RPM).
duplex (Management) Set the mode of the Management interface.
management route Configure a static route that points to the Management interface or a
forwarding router.
backup
interface Use this option to configure a redundant Layer 2 link without using Spanning Tree. This
keyword configures a backup port so that if the primary port fails the backup port
changes to the up state. If the primary later comes up, it becomes the backup.
gigabit
Enter this keyword if the backup port is a 1G port.
tengigabit
Enter this keyword if the backup port is a 10G port.
port-channel
Enter this keyword if the backup port is a static or dynamic port channel.
slot/port
Specify the line card and port number of the backup port.