Dell Force10 TeraScale C Series, Reference Manual

Page: 162 / 1640

162 | Control and Monitoring
www.dell.com | support.dell.com
virtual-ip
c e
Configure a virtual IP address for the active management interface. Virtual addresses can be
configured both for IPv4 and IPv6 independently.
Syntax virtual-ip { ipv4-address | ipv6-address }
Parameters
Defaults No default behavior or values
Command Modes CONFIGURATION
Command
History
Usage
Information
Both IPv4 and IPv6 virtual address can be configured simultaneously, but only one of each. Each time
this command is issued it will replace the previously configured address of the same family, IPv4 or
IPv6. The
no virtual-ip
command now takes an address/prefix-length argument, so that the desired
address only is removed. If
no virtual-ip
is entered without any specified address, then both IPv4 and
IPv6 virtual addresses are removed.
Example Figure 5-65. Command Example: virtual ip (IPv4 and IPv6)
write
c e s
Copy the current configuration to either the startup-configuration file or the terminal.
Syntax write
{
memory
|
terminal
}
Parameters
Command Modes EXEC Privilege
Command
History
{ ipv4-address |
ipv6-address }
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::) of the active
management interface.
Version 8.4.1.0 Added support for IPv6 addressing.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
FTOS#virtual-ip 10.11.197.99/16
FTOS#virtual-ip fdaa:bbbb:cccc:1004::60/64
memory
Enter the keyword
memory
to copy the current running configuration to the startup
configuration file. This command is similar to the
copy running-config
startup-config
command.
terminal
Enter the keyword
terminal
to copy the current running configuration to the terminal. This
command is similar to the
show running-config
command.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command