Dell EMC VxFlex Ready Node R840, Manual

Page: 123 / 218

Che
ck
List Task Topic
☐
5 Disconnect the power cords
and I/O cables. See Disconnect the power cords and I/O cables on page
164.
☐
6 Extend the system from the
cabinet. See Extend the system from the cabinet on page 164.
☐
7 Remove the system cover. See Remove the system cover on page 173.
☐
8 Remove the NIC from the
expansion card riser. See Remove the expansion card from the expansion
card riser on page 101.
☐ 9 Install the NIC into the
expansion card riser. See Install the expansion card into the expansion card
riser on page 105.
☐ 10 Install the system cover. See Install the system cover on page 173.
☐ 11 Slide the system into the
cabinet.
See Slide the system into the cabinet on page 165.
☐ 12 Connect the I/O cables and
power cords.
See Connect the I/O cables and power cords on page
164.
☐
13 Install the bezel. See Install the front bezel on page 166.
Perform mandatory software tasks to return the node to operation:
☐
14 Verify the NIC in system
setup.
See "Network card replacement procedural checklist" in
the VxFlex Ready Node Field Replacement Unit Software
Guide
. Perform the relevant tasks, starting with "" until
you are directed back to this guide for Verify the NIC in
System Setup (BIOS)."
☐
15 Verify the new network card
in the server.
☐ 16 Return the node to
operation.
Installing an optional NIC
Use the following procedure to install a network interface card when the first NIC is
installed in the network daughter card.
This procedure is for Data Domain scenarios when a BOSS card is not used.
Note
Before starting this FRU procedure, familiarize yourself with the topics in Important
information before performing a FRU procedure on page 56.
CAUTION
This FRU procedure requires you to perform mandatory software tasks in VxFlex
OS, as described in the
VxFlex Ready Node Field Replacement Unit Software Guide .
You will be referred to these mandatory software tasks in the following checklist.
Hardware FRU procedures
Installing an optional NIC 123